Routine
July 30, 2026
- Risk factorsItems found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
- 2
- Retail practicesItems 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
- 2
- RepeatViolations the department marks as repeated from an earlier inspection.
- 0
Risk factors 2
- 16
Food-contact surfaces; cleaned and sanitized4-501.114(A)
Chlorine sanitizer concentration was observed to be between 0-10 parts per million (ppm), which is below the minimum ppm to properly sanitize in the bar dish washing machine. Provide 50ppm-200ppm chlorine concentration to ensure food-contact surfaces are effectively sanitized. Corrected on site PIC changed out old bottle of Cl sanitizer to measure 50ppm.
- 23
Proper date marking and disposition3-501.18(A)(1)
Observed there to be foods stored in the 6 door cooler that were kept beyond the 7 day allowed timeframe (i.e. Cesar dressing dated 7/23 and horsecream dated 7/22). Foods shall be discarded if it exceeds the time/temperature combination specified in 3-501.17 (A). PIC discarded foods voluntarily.
Retail practices 2
- 47
Food and non-food contact surfaces cleanable, properly designed, constructed, and used4-202.16
Observed the exterior parts of the oven as well and areas inside the oven to be rusted and no longer smooth and easily cleanable. Non-food contact surfaces are not designed and constructed to allow for easily cleaning. Rusted surfaces need to be replaced or cleaned so that the oven is functional and surfaces are smooth and easily cleanable.
- 56
Adequate ventilation and lighting; designated areas used4-204.11
Grease was found dripping from the components of the exhaust ventilation hood system. Exhaust ventilation hood systems in food preparation and ware washing areas including components such as hoods, fans, guards, and ducting shall be designed to prevent grease or condensation from draining or dripping onto food, equipment, utensils, linens, and single-service and single-use articles. Clean areas of hood system as needed to prevent grease build up and dripping.


The inspector’s comments
Core Violations noted on this inspection shall be corrected within 90 calendar days, or by no later than the next routine inspection if no health hazard exists or will result from allowing the extended schedule for compliance. This comment shall serve as a written extended schedule of compliance as agreed upon by the permit/license holder and the regulatory authority.