Routine
September 14, 2026
- Risk factorsItems found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
- 3
- Retail practicesItems 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
- 5
- RepeatViolations the department marks as repeated from an earlier inspection.
- 0
Risk factors 3
- 16
Food-contact surfaces; cleaned and sanitized4-501.114(A)
Chlorine sanitizer concentration is 10 parts per million (ppm), which is below the minimum ppm to properly sanitize in sanitizer. Provide 50ppm-200ppm chlorine concentration to ensure food-contact surfaces are effectively sanitized. Corrected on site by manager remaking sanitizer bucket to 100ppm.
- 16
Food-contact surfaces; cleaned and sanitized4-602.11(A)(5)
Observed the following food contact surfaces and/or utensils to be soiled or not clean to sight and touch: can opener blade. Equipment and food contact surfaces and utensils shall be cleaned at any time during food operations when contamination may have occurred. Corrected by PIC washing can opener.
- 28
Toxic substances properly identified, stored and used7-102.11
Observed spray bottle of degreaser and sanitizer not in original container to be missing common name label. Working containers used for storing poisonous or toxic materials such as cleaners and sanitizers should be be clearly and individually labeled when removed from the original packaging. Corrected on site by PIC placing labels on spray bottles.
Retail practices 5
- 37
Food properly labeled; original container3-302.12
Observed bulk foods in non original container without common name label on outside of new container it is stored in (pasta seasonings). Working containers of food or food ingredients that have been removed from the original packaging and could be easily mistaken for other ingredients shall be identified with the common name of the food. Label container. Corrected on site by PIC placing label on container.
- 47
Food and non-food contact surfaces cleanable, properly designed, constructed, and used4-501.11
Observed door gasket on walk in cooler reach in cooler to be in a state of disrepair . Equipment shall be maintained in good repair, such as doors, seals, hinges, and kick plates kept intact and tight. To be corrected by next routine inspection by replacing gasket/seal.
- 55
Physical facilities installed, maintained, and cleaned6-501.12
Observed ceilings of back kitchen to have excess accumulation of dust. Floors, walls, and ceilings shall be cleaned as often as necessary to keep them clean. Except for cleaning up a spill or other accident, cleaning should be done during periods when the least amount of food is exposed such as after closing. Correct by regularly cleaning.
- 55
Physical facilities installed, maintained, and cleaned6-201.11
Floors in kitchen area were observed to be chipped and cracked. Except as specified in Section 6-201.14 and except for antislip floor coverings or applications that may be used for safety reasons, floors, floor coverings, walls, wall coverings, and ceilings shall be designed, constructed, and installed so they are smooth and easily cleanable. Correct by replacing tiles.
- 56
Adequate ventilation and lighting; designated areas used6-202.12
Make-up air / Exhaust vents in the kitchen area were found with accumulation of dust on them. Heating, ventilating, and air conditioning systems shall be designed and installed so that make-up air intake and exhaust vents do not cause contamination of food, food-contact surfaces, equipment, or utensils. Correct by cleaning.


The inspector’s comments
Core Violations noted on this inspection shall be corrected within 90 calendar days, or by no later than the next routine inspection if no health hazard exists or will result from allowing the extended schedule for compliance. This comment shall serve as a written extended schedule of compliance as agreed upon by the permit/license holder and the regulatory authority.