Routine
October 19, 2026
- Risk factorsItems found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
- 0
- Retail practicesItems 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
- 3
- RepeatViolations the department marks as repeated from an earlier inspection.
- 0
Retail practices 3
- 47
Food and non-food contact surfaces cleanable, properly designed, constructed, and used4-501.11
Observe the gasket of the right door in the Turbo Air cooler to be cracked/broken. Equipment shall be maintained in good repair, such as doors, seals, hinges, and kick plates kept intact and tight. Replace gasket.
- 49
Non-food contact surfaces clean4-602.13
Observed there to be soiled residue on the handles and doors of the Turbo air cooler and Kelvinator freezer back prep area. Nonfood-contact surfaces of equipment shall be cleaned as often as necessary to maintain free of soil residues.
- 56
Adequate ventilation and lighting; designated areas used6-202.12
Make-up air / Exhaust vents in the back prep/ ware washing area were found with accumulation of dust on them. Heating, ventilating, and air conditioning systems shall be designed and installed so that make-up air intake and exhaust vents do not cause contamination of food, food-contact surfaces, equipment, or utensils. Clean as often as needed to reduce the accumulation of dust and possibility of food contamination.


The inspector’s comments
Core Violations noted on this inspection shall be corrected within 90 calendar days, or by no later than the next routine inspection if no health hazard exists or will result from allowing the extended schedule for compliance. This comment shall serve as a written extended schedule of compliance as agreed upon by the permit/license holder and the regulatory authority.