Routine
July 1, 2026
- Risk factorsItems found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
- 1
- Retail practicesItems 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
- 2
- RepeatViolations the department marks as repeated from an earlier inspection.
- 1
Risk factors 1
- 28
Toxic substances properly identified, stored and used7-204.11
(A) Observed Chlorine sanitizer to be >200ppm. Chemical sanitizers, including chemical sanitizing solutions generated on-site, and other chemical antimicrobials applied to food-contact surfaces shall meet the requirements specified in 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (Food-contact surface sanitizing solutions). Corrected by PIC adding water and retesting solution at 100ppm.
Retail practices 2
- 49
Non-food contact surfaces clean4-601.11(C)
Buildup present on reach in cooler shelving and gaskets of coolers. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Correct by cleaning surfaces.
- 56
Adequate ventilation and lighting; designated areas used4-204.11
Observed grease to be dripping from the components of the exhaust ventilation hood system. Exhaust ventilation hood systems in food preparation and warewashing areas including components such as hoods, fans, guards, and ducting shall be designed to prevent grease or condensation from draining or dripping onto food, equipment, utensils, linens, and single-service and single-use articles. Ensure components of the exhaust ventilation hood system are in good working condition and clean hood as needed to prevent grease from dripping.


The inspector’s comments
Core Violations noted on this inspection shall be corrected within 90 calendar days, or by no later than the next routine inspection if no health hazard exists or will result from allowing the extended schedule for compliance. This comment shall serve as a written extended schedule of compliance as agreed upon by the permit/license holder and the regulatory authority. EHS recommends the use of temperature logs for both walk-in coolers and standalone reach-in refrigeration units. EHS has provided the Person in Charge (PIC) with temperature log sheets and advises that temperatures be recorded every 24 hours. Please note that if Time/Temperature Control for Safety (TCS) foods are found to be out of the required temperature range in the future and temperature logs are not being maintained, EHS may require the affected food items to be discarded, regardless of the duration of the temperature deviation.