Routine
April 28, 2026
- Risk factorsItems found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
- 0
- Retail practicesItems 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
- 1
- RepeatViolations the department marks as repeated from an earlier inspection.
- 0
Retail practices 1
- 48
Warewashing facilities: installed, maintained, and used; test strips4-501.15
Observed dish machine to not reach temperatures in accordance of manufacturers data plate. Data plate states 160F minimum wash cycle, 180F minimum for rinse. Employee stated that the machine had been reaching over 200F for rinse cycle after service. Ware washing machine is not operated in accordance with the manufacturer's instructions. To be corrected by next routine inspection. (C).


The inspector’s comments
During inspection employee stated that the dish machine had been serviced since last inspection. Machine was ran 3 times, an irreversible temperature sticker was used to take surface temperature which reached 160. Temperature gauge/screen was not reading correct temperatures (wash cycle - 160, Rinse - 116). Employee stated that rinse cycle was reaching above 200F. Fresh hot water SANITIZING rinse as it enters the manifold may not be more than 194F, or less than 180F. Establishment shall have professional service dish machine so the final sanitizing rinse does not reach higher than 194F. Person in charge stated they have put in an order to have dish machine replaced.