Routine
October 23, 2026
- Risk factorsItems found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
- 2
- Retail practicesItems 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
- 2
- RepeatViolations the department marks as repeated from an earlier inspection.
- 0
Risk factors 2
- 10
Adequate handwashing sinks properly supplied and accessible
6-301.12(A)-(D) Handwashing sink located by dish machine was not provided with one of the following acceptable means of hand drying: (A) individual, disposable towels (B) a continuous towel system that supplies the user with a clean towel (C) a heated-air drying device or (D) A hand drying device that delivers high velocity, pressurized air. Corrected by PIC supplying paper towels.
- 16
Food-contact surfaces; cleaned and sanitized4-501.114(A)
Chlorine sanitizer concentration is 10 parts per million (ppm), which is below the minimum ppm to properly sanitize in sanitizer bucket in the area. Provide 50ppm-200ppm chlorine concentration to ensure food-contact surfaces are effectively sanitized. Corrected by employee PIC adding more bleach to the water to 100 ppm.
Retail practices 2
- 47
Food and non-food contact surfaces cleanable, properly designed, constructed, and used4-501.11
Observed gaskets of freezer are torn and in disrepair.. Equipment shall be maintained in good repair, such as doors, seals, hinges, and kick plates kept intact and tight. Correct by replacing gaskets.
- 49
Non-food contact surfaces clean4-601.11(C)
Observed mold growth on cooler gaskets in bar area. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Correct by regularly cleaning and sanitizing gaskets.


The inspector’s comments
Core Violations noted on this inspection shall be corrected within 90 calendar days, or by no later than the next routine inspection if no health hazard exists or will result from allowing the extended schedule for compliance. This comment shall serve as a written extended schedule of compliance as agreed upon by the permit/license holder and the regulatory authority.