WhiskeyCivic
Food inspections

Peoria Marriott Pere Marquette Banquet Kitchen

Address
501 Main ST, Peoria 61602
Kind
Restaurant
Permit
143-5379

Latest inspection

Follow Up Fee 1

October 7, 2026

Risk factorsItems found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
0
Retail practicesItems 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
0
RepeatViolations the department marks as repeated from an earlier inspection.
0

No violations recorded.

The inspector’s comments

Establishment has not submitted proof of allergen training for Ajene Evans to EHS. Establishment must submit proof of Allergen Awareness Training for Ajene Evans to ayepsen@peoriacounty.org by 11/9/26 to avoid further follow-up inspections and associated fees. Be advised, the following violation documented on the last inspection have not been corrected and will be considered a continuous violation if not corrected prior to, or at, the Second Follow-Up Inspection. Be further advised that follow-up inspections fees shall apply, and continued noncompliance may result in a referral to the Director of Environmental Health for additional enforcement action.

This inspection on the portal

Earlier inspections 7

Routine

September 4, 2026

Risk factors
2
Retail practices
7
Repeat
0

Risk factors 2

  1. 10

    Adequate handwashing sinks properly supplied and accessible

    Priority foundation

    6-301.12(A)-(D) Handwashing sink located at dish machine was not provided with method of drying hands. Handsinks shall have one of the following acceptable means of hand drying: (A) individual, disposable towels (B) a continuous towel system that supplies the user with a clean towel (C) a heated-air drying device or (D) A hand drying device that delivers high velocity, pressurized air. Corrected by employee providing hand sink with paper towels.

  2. 16

    Food-contact surfaces; cleaned and sanitized

    Priority foundation

    4-601.11(A)Observed can opener blade not clean to sight and touch. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Corrected by employee cleaning and sanitizing blade so that it is clean to sight touch.

Retail practices 7

  1. 47

    Food and non-food contact surfaces cleanable, properly designed, constructed, and used4-501.11

    Observed gasket of Walk in freezer torn and in disrepair with icing observed at entrance. Equipment shall be maintained in good repair, such as doors, seals, hinges, and kick plates kept intact and tight. Correct by replacing gasket.

  2. 49

    Non-food contact surfaces clean4-601.11(C)

    Observed buildup and soil accumulation on prep sink within kitchen. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Correct by cleaning surface.

  3. 51

    Plumbing installed; proper backflow devices5-205.15(B)

    Plumbing is not maintained in good repair at the hand sink handles within main kitchen and serving area. Plumbing systems shall be maintained in good repair to prevent escalating issues, i.e., leaks addressed with urgency. Correct by repairing leaks.

  4. 54

    Garbage and refuse are properly disposed; facilities are maintained5-501.16(C)

    A waste receptacle is not provided at the handwashing sink located at dish and serving areas. When disposable towels are used at a handwashing sink, a waste receptacle shall be located nearby. Correct by providing waste receptacle.

  5. 55

    Physical facilities installed, maintained, and cleaned6-501.11

    Observed floors within WIC to be lifting off floor. Floors, walls, ceilings, and other physical facilities shall be maintained in good repair. Correct by repairing floor.

  6. 56

    Adequate ventilation and lighting; designated areas used6-202.12

    Make-up air / Exhaust vents in the dish area were found with accumulation of dust and soil on them. Heating, ventilating, and air conditioning systems shall be designed and installed so that make-up air intake and exhaust vents do not cause contamination of food, food-contact surfaces, equipment, or utensils. Correct by cleaning vents.

  7. 58

    Allergen awareness training for CFPMPeoria County Code [Section 10-29(C)]

    All required Certified Food Protection Managers (CFPMs) must complete additional allergen training using an ANSI approved Allergen Awareness Training program. Certificate of course completion must be kept at the establishment and made available upon request. A list of ANSI accredited Allergen Awareness Training programs can be found at ansi.org. -Submit proof of Allergen Training to ayepsen@peoriacounty.org by 10/5/26 to avoid follow-up inspection and associated fee.

The inspector’s comments

-Submit proof of Allergen Training to ayepsen@peoriacounty.org by 10/5/26 to avoid follow-up inspection and associated fee.

This inspection on the portal

Complaint Investigation (non-FBI)

August 25, 2026

Risk factors
0
Retail practices
0
Repeat
0

No violations recorded.

The inspector’s comments

This inspection was done in response to a complaint received by the Peoria City/County Health Department, reference RFS#26-0409, stating that establishment is operating while sewage is backing up. EHS arrived onsite and discussed nature of complaint with PIC. PIC stated that the Banquet kitchen has not been used in over a week and was not aware of any issues in regards to sewage backing up. EHS ran water from several fixtures within Banquet kitchen and did not observe any issues in regards to conveying grey water at time of inspection. EHS walked with PIC to separate kitchens within same building, under the licenses of Fox and Ford and the Courtyard. EHS ran water at each location and did not observe any issues regarding plumbing or conveying of sewage at time of inspection. EHS spoke with the buildings maintenance crew whom stated they did have to clean out the pea trap of the dish washing machine located within the main kitchen (Fox and Ford) which had led to water not being able to be drained through the pipes. EHS did not observe any issues with the dish machine plumbing conveying sewage at time of inspection. EHS recommends closing out RFS at this time.

This inspection on the portal

Follow Up Fee 3

April 20, 2026

Risk factors
0
Retail practices
0
Repeat
0

No violations recorded.

The inspector’s comments

This was a follow up fee 3 to a routine inspection on February 21, 2026. It was observed that the heat sanitizing dish machine was not able to reach the final rinse temperature minimum of 180F. Upon arrival dish machine had ran a cycle and test with metal stem thermometer and temp rite irreversible sticker. Metal stem thermometer had reached a max temp of 181 and surface temp rite sticker reached 160F. Dish machine appears to now be working properly reaching minimum temperatures for cycle. No further action is needed for this violation. This was a charge (fee) follow up inspection.

This inspection on the portal

Follow Up Fee 2

April 6, 2026

Risk factors
0
Retail practices
0
Repeat
0

No violations recorded.

The inspector’s comments

This is a Follow up Fee 2 inspection to a routine inspection on February 21, 2026 where it was observed that the banquet kitchen heat sanitizing dish machine was not able to reach minimum final rinse temperature of 180F per manufacturers requirements. Upon arrival on PIC stated that dish machine had not been fixed yet as part is on back order and had been ordered the previous week. Establishment shall have until 4/20/2026 to correct the violation and have dishwasher fixed by licensed professional. This was a charged (feed) follow up inspection.

This inspection on the portal

Follow Up Fee 1

March 20, 2026

Risk factors
1
Retail practices
1
Repeat
1

Risk factors 1

  1. 16

    Food-contact surfaces; cleaned and sanitized4-501.112(A)

    Priority foundation

    Observed the dish machines final rinse temperature to be over 194F. Gauges read 208F, EHT thermometer screen melted. In a mechanical operation, the temperature of the fresh hot water SANITIZING rinse as it enters the manifold may not be more than 90oC (194oF), or less than: To be corrected by 4/3/2026

Retail practices 1

  1. 48

    Warewashing facilities: installed, maintained, and used; test strips4-204.115

    Priority foundation

    Observed pre wash, wash, rinse, final rinse gauges to not be working properly on heat sanitizing dish machine. Measuring devices are needed at all locations to ensure proper function of the warewashing unit and final sanitizing step. To be corrected by 4/3/2026

The inspector’s comments

This was a charged follow up inspection to a routine inspection on February 21, 2026, where it was observed that the banquet kitchen heat sanitizing dish machine was not able to reach minimum final rinse temperature of 180F per manufacturers requirements. Due to the size of machine establishment was given an extension from original correction date of 3/6/2026 to 3/20/2026 to be repaired. Upon arrival on 3/20/2026 it was observed that the dish machine temperature is too high (208F) for final rinse after running machine multiple times which is higher the Food Code allows (max 194F) as well as manufactures minimum temperature of 180F. PIC stated the final rinse gauge and pressure gauge had been replaced. EHT observed that none of the temperature gauges are working properly (pre wash, wash, rinse, final rinse). The wash and rinse gauge dials do not move at all and the final rinse gauge does not move back to 0F and stays at 140F. All other gauges stay at 140F and do not move during machine operation. Establishment shall continue to bring soiled dishes to other kitchens dish machine that is on site. A license professional shall be used to repair dish machine gauges as well as correct the final rinse temperature to be between 180F-194F. This was a charged (fee) follow up visit.

This inspection on the portal

Administrative Follow-Up

February 27, 2026

Risk factors
0
Retail practices
0
Repeat
0

No violations recorded.

The inspector’s comments

This is an administration follow up to a routine inspection on February 21, 2026, where it was observed the heat sanitizing dishwasher was not meeting minimum temperature to sanitize dishware. Original correct by date was March 3, 2026 but establishment was allowed to ask for extension due to size and cost of machine if repair or replacement was not feasible before said date. Person in charge contacted EHT to inform them they needed an extension as they are waiting for parts to complete repair that will not be completed by 3/6/2026 and will provide updates to EHT of when they receive parts for repair. Extension has been given to establishment who shall continue to take soiled dishware to downstairs kitchen (Fox and Ford) for sanitizing until banquet dish machine is repaired a providing adequate minimum temperatures. To be corrected by 3/20/2026.

This inspection on the portal

Routine

February 21, 2026

Risk factors
4
Retail practices
1
Repeat
0

Risk factors 4

  1. 10

    Adequate handwashing sinks properly supplied and accessible6-301.11

    Priority foundationCorrected on site

    observed hand sink by coffee machine/maker to be out of hand soap. Hand sinks shall be supplied with hand cleaning liquid, powder, or bar soap. Corrected on site by person in charge filling hand soap dispenser.

  2. 16

    Food-contact surfaces; cleaned and sanitized4-501.112

    Priority foundation

    Observed heat sanitizing non stationary dishwasher max temperature of 170F, which is below the minimum final rinse temperature of 180 (manufacturer minimum) and maximum of 194F. The temperature of the fresh hot water SANITIZING rinse as it enters the manifold may not be more than 90C (194F), or less than or meet manufactures minimum requirements. EHT discussed with person in charge that shall bring all dirty dishes from kitchen to ware washing machine down stairs to other kitchen (Fox and Ford) To be corrected by 2/6/2026, if extension is needed due to not being able to get repair professional out in time contact inspector

  3. 22

    Proper cold holding temperatures3-501.16(A)(2)

    PriorityCorrected on site

    and (B) Observed two cartons of liquid whole eggs to be sitting out on prep table, egg temperatures read 61F (metal stem thermometer used). Label stated to keep refrigerated at 33F-40F. Time/temperature control for safety food is not held cold at 41F or below (45F or below for raw eggs). TCS foods shall be held at 41F or below (45F or below for raw eggs) as measured by a calibrated food temperature measuring device. Corrected on site by employee throwing liquid egg cartons away.

  4. 23

    Proper date marking and disposition3-501.17(A)

    Priority foundationCorrected on site

    Observed missing 7 day date mark on opened milk in produce walk in cooler, as well as a container of liquid eggs in non original container. Refrigerated, ready-to-eat, tcs foods that are prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded when held at 41F or less for a maximum of 7 days. Corrected on site by person in charge placing date on milk that was opened earlier this morning

Retail practices 1

  1. 37

    Food properly labeled; original container3-302.12

    Observed 3 containers missing a common name that were not in original packaging, (2 white granule containers, and 1 mixed spice/flour mixture). Working containers of food or food ingredients that have been removed from the original packaging and could be easily mistaken for other ingredients shall be identified with the common name of the food. Label container. To be corrected by next routine inspection. (C).

The inspector’s comments

During inspection it was observed that the heat sanitizing dish washer gauges did not work. A max temperature of dishwasher was taken (4 times), was seen to only reach 170F. Irreversible surface temperature stickers was placed on dish and was observed to reach 160F. Corporate employee was also inspecting dish machine and was aware of its issues and was determining the capacity needs of establishment as to expedite repair or possible new dish machine installation. EHT informed person in charge that staff can rinse dishes in this kitchen but must bring them to other ware washing machine on premise down stairs (Fox and Ford) to be properly sanitized. Due to size and cost of machine it is understood that repair or replacement may take longer than 10 business days. If more time is needed to repair (by licensed professional) or replace person in charge shall contact inspector for extension of time but shall continue to bring dirty dishware/utensils to second kitchens dish machine on premise to be cleaned and sanitized. Inspector contact: kcaudle@peoriacounty.gov

This inspection on the portal

What the counts mean
Risk factors
Items found out of compliance among the 29 on the state’s inspection form most closely tied to foodborne illness, such as holding temperatures and handwashing. One corrected while the inspector was there still counts.
Retail practices
Items 30 and up on the form found out of compliance: cleanliness, equipment, labeling, allergen notices and the like. One corrected while the inspector was there still counts.
Repeat
Violations the department marks as repeated from an earlier inspection.

Report a mistake